Built for the ARRI ALEXA 35, Wooden Camera's Elite Accessory System is a modular cage system that works with your preferred accessories and adapts quickly to each shooting scenario. It includes the Base Plate System, Side Rail System and Top Plate System for the ALEXA 35, an Ultra Handle System (Universal 3/8"-16), a Handle Adaptor Kit for CCH-5, an Accessory Kit for PDM-1 and an Antenna Relocation Bracket.

Base plate and side rails

The Base Plate System pairs the ARCA Baseplate (ALEXA 35) with an ARCA Base Plate. Low profile, it fits any make of bridge plate built to ARRI standard height, with a low centre of gravity for adding shoulder pads and accessories. Double-locking, lens-centred front and rear rod clamps resist torque and rotation from lens motors. The Side Rail System's two rails fit the sensor body's sides, each with a DLC-coated stainless steel rosette, a forward-facing 3/8"-16 point, two 3/8"-16 and two 1/4"-20 mounting points, a sensor-plane mark and a swing-out tape hook.

Top plate and handles

The three-piece Top Plate System's bolt pattern lets rod brackets and accessories mount anywhere on top of the camera body. Its front, middle and rear plates come with a Top Plate Dual Rod Clamp (front) and a Top Plate 15mm Upper Dual Rod Clamp. The Handle Adaptor Kit's 15mm rod bracket and adaptor plate fit ARRI's CCH-5 handle to the Wooden Camera top plate. The Ultra Handle System adds two 5" handles, a 3" handle, 1" and right-angle extensions, universal front and rear uprights and 24 colour rings.

PDM-1 and antennas

The Accessory Kit for PDM-1 adds an Accessory Block, with three 3/8"-16 mounting points and anti-twist pinholes, and a Dual Rod Bracket to the top of the ARRI PDM-1. Designed to improve the camera's wireless connection, the Antenna Relocation Bracket moves the two rear Wi-Fi antennas, on its 6" cables, to any 3/8"-16 ARRI anti-twist mount point on the rig, such as the top handle or the PDM-1. No antennas come with it. The complete system weighs 1521 g and measures 203 x 139 x 122 mm.